Technicians available today

Washer Not Spinning?

If your washer is not spinning or your clothes come out soaking wet after the cycle, the machine is failing to complete the final spin. This can happen because of a simple load issue, but it can also point to a drain, lock, motor, belt, or control problem.

Fast Book Online Service call fee $0 - $35 / Original parts / Budget friendly

Why Your Washer Is Not Spinning

The spin cycle depends on drainage, balance, door lock safety, motor power, and control signals. If one of these systems fails, the washer may stop before spinning, spin weakly, or leave clothes wet.

Lid lock or door lock failure — the washer will not spin if it cannot confirm the lid is locked.
Drain problem — if water stays inside, many washers will block the spin cycle.
Worn belt or motor issue — the drum may not have enough power to spin properly.
Unbalanced load or suspension problem — the washer may stop to protect itself.
Control board or sensor issue — the washer may not send the correct command to start spin.

Common Signs

Clothes are still wet after the cycle
Washer drains but does not spin
Washer starts spinning, then stops
Machine shakes or bangs before spin
Error code appears during the final cycle

Quick Advice Before Calling

Try a smaller load and spread clothes evenly inside the drum.
Run a separate drain/spin cycle if your washer has one.
Check if water remains inside the drum after the cycle.
Do not keep forcing the washer if it shakes violently or makes grinding noise.

If the problem continues, it is better to diagnose it before replacing parts or buying a new washer.